Owner manual

About the Command-Line Interface (CLI)

________________________________________________________________________

With the Command-Line Interface (CLI) you can perform basic configuration tasks, as well as fine-

tune and manage your ION Accelerator system.

For an introduction to ION Accelerator, as well as First Boot instructions and a variety of best

practices and configuration information, refer to the ION Accelerator Configuration Guide.

Many of the CLI commands can affect data or configurations on a wide variety of devices. Be

sure to use the commands with caution, or try them on a test system if you are unsure of

their potential effects. Use the

--help option with any command to see its command syntax

and usage.

Command Groups

The commands are arranged in the following groups:

• Help, etc. • Bus • Chassis • Cluster

• CNA • Config • CPU • Drive

• Fan • FIO • Format • Inigroup

• Initiator • Kdump • Log • LUN

• Manage • Network • Node • Pool

• Port • Profile • PSU • RAID

• Rules • SAFT • Service • Shell

• SNMP • Software • SSH • System

• Target • Temp (Temperature) • View • Volume