Personal Computer User Manual

Removing and Installing Parts: Dell Dimension 9150 Service Manual
file:///T|/htdocs/systems/dim9150/en/sm/parts.htm[10/31/2012 7:59:36 AM]
If you removed an add-in network connector:
1. Enter system setup
, select Integrated NIC Controller, and then change the setting to On.
2. Connect the network cable to the integrated connector on the back panel of the computer.
Drive Panels
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.
Removing the Drive Panel
1. Follow the procedures in "Before You Begin."
2. Grasping the lever on the sliding plate, pull the sliding plate to the right and hold in place.
NOTE: The sliding plate secures and releases the drive panel and helps to secure the drives.
3. Push from the inside and pivot the drive panel to the left to release the panel from its side hinges.
4. Set the drive panel aside in a secure location.