Service Manual
Table Of Contents
- Latitude 5530 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5530
- Subscriber Identity Module (SIM) card
- Micro Secure Digital (SD) Card
- Base cover
- WLAN card
- WWAN card
- Solid-state drive
- Memory modules
- Battery
- Battery cable
- Assembly inner frame
- LED board
- System fan
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Display hinges
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Auto RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Next steps
1. Install the 3-cell battery or 4-cell battery.
2. Install the base cover.
3. Install the microSD card.
4. Install the SIM card.
5. Follow the procedure in after working inside your computer.
Removing the heat sink (for computers shipped with discrete
graphics card)
Prerequisites
1. Follow the procedure in before working inside your computer.
NOTE: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
2. Remove the SIM card.
3. Remove the microSD card.
4. Remove the base cover.
5. Remove the 3-cell battery or 4-cell battery.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the removal procedure.
56
Removing and installing components