Service Manual
Table Of Contents
- Latitude 5530 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5530
- Subscriber Identity Module (SIM) card
- Micro Secure Digital (SD) Card
- Base cover
- WLAN card
- WWAN card
- Solid-state drive
- Memory modules
- Battery
- Battery cable
- Assembly inner frame
- LED board
- System fan
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Display hinges
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Auto RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Steps
1. Open the latch and disconnect the smart-card reader cable from the connector on the USH-daughter board.
2. Remove the smart-card reader cable away from the USH-daughter board.
3. Disconnect the LED-board cable from the connector on the system board and unroute the cable.
4. Remove the (M2x3) screw that secures the LED board to the palm-rest assembly.
5. Lift the LED board along with the cable away from the palm-rest assembly.
Installing the LED board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the LED board and provides a visual representation of the installation procedure.
50
Removing and installing components