Service Manual
Table Of Contents
- Latitude 5530 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5530
- Subscriber Identity Module (SIM) card
- Micro Secure Digital (SD) Card
- Base cover
- WLAN card
- WWAN card
- Solid-state drive
- Memory modules
- Battery
- Battery cable
- Assembly inner frame
- LED board
- System fan
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Display hinges
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Auto RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Steps
1. Unroute the antenna cables from the routing guides on the assembly inner frame.
2. For computers shipped with fingerprint reader:
a. Remove the screw (M2x4) that secures the fingerprint bracket to the assembly inner frame.
b. Disconnect the speaker cable from the connector on the system board, and unroute the speaker cable from the routing
guides on the assembly inner frame.
c. Remove the eleven (M2x3) screws that secure the assembly inner frame to the system board and the palm-rest
assembly.
3. For computers shipped with power button only:
a. Disconnect the speaker cable from the connector on the system board, and unroute the speaker cable from the routing
guides on the assembly inner frame.
b. Remove the twelve (M2x3) screws that secure the assembly inner frame to the system board and the palm-rest
assembly.
4. Lift the assembly inner frame off the system board and the palm-rest assembly.
Installing the assembly inner frame
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the assembly inner frame and provides a visual representation of the installation
procedure.
Removing and installing components
47