Service Manual
Table Of Contents
- Latitude 5530 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5530
- Subscriber Identity Module (SIM) card
- Micro Secure Digital (SD) Card
- Base cover
- WLAN card
- WWAN card
- Solid-state drive
- Memory modules
- Battery
- Battery cable
- Assembly inner frame
- LED board
- System fan
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Display hinges
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Auto RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Figure 8. M.2 2230 solid-state drive with bracket
Steps
1. Installing M.2 2230 solid-state drive without bracket:
a. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
b. Slide the M.2 2230 solid-state drive at an angle into its slot on the system board.
c. Replace the (M2x4) screw to secure the M.2 2230 solid-state drive to the system board.
2. Installing M.2 2230 solid-state drive with bracket:
a. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
b. Slide the M.2 2230 solid-state drive at an angle into its slot on the system board.
c. Replace the (M2x4) screw to secure the solid-state drive to the system board.
d. Align the screw holes on the solid-state drive bracket with the screw holes on the system board.
e. Replace the two (M2x3) screws to secure the solid-state drive bracket to the system board.
Next steps
1. Install the base cover.
2. Install the microSD card.
3. Install the SIM card.
4. Follow the procedure in after working inside your computer.
Memory modules
Removing the memory modules
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SIM card.
3. Remove the microSD card.
4. Remove the base cover.
About this task
The following images indicate the location of the memory modules and provide a visual representation of the removal procedure.
34
Removing and installing components