Service Manual
Table Of Contents
- Latitude 5530 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5530
- Subscriber Identity Module (SIM) card
- Micro Secure Digital (SD) Card
- Base cover
- WLAN card
- WWAN card
- Solid-state drive
- Memory modules
- Battery
- Battery cable
- Assembly inner frame
- LED board
- System fan
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Display hinges
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Auto RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Figure 3. M.2 2280 solid-state drive without bracket
Figure 4. M.2 2280 solid-state drive with bracket
Steps
1. Installing M.2 2280 solid-state drive without bracket:
a. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
b. Slide the M.2 2280 solid-state drive at an angle into its slot on the system board.
c. Replace the (M2x4) screw to secure the M.2 2280 solid-state drive to the system board.
2. Installing M.2 2280 solid-state drive with bracket:
a. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
b. Slide the M.2 2280 solid-state drive at an angle into its slot on the system board.
Removing and installing components
29