Installation guide

The Cluster Wizard will create only one OCFS drive for data les. If you would like to create addional OCFS drives from the logical
parons you created earlier, do the following:
1. Use Windows Disk Management tool to assign the unformaed logical paron a driver leer.
• Start disk Manager, locate the logical paron you would like to format for OCFS, and right click inside the paron. Select
“Change Drive Leer and Paths...” In the “Change Drive Leer and Paths for..” window select the “Add” buon and select
the drive leer you wish to assign the paron from the drop down list.
2. Use the “OcfsFormat” command to format for OCFS:
OcfsFormat /l G: /c 10240 /v u02 /f
where l is the drive leer, c is the cluster size (kb), v is the volume label, and f forces the format
3. Reboot the other nodes. Aer reboot, check the OCFS paron in Disk Management. All nodes must have the same drive
leer.
Install the 2.2.0.18 Version of the Oracle Universal Installer
Perform the following steps to install OUI version 2.2.0.18:
1. Open a command prompt window.
2. Navigate to the E:\oracle_stage\oui22018\install\win32 directory.
3. Run setup.exe.
4. In the “OUI Welcome screen”, click “Next”.
5. In the “Cluster Node Selecon” screen, highlight all nodes {if installing on individual nodes, only select the current node).
6. In the next screen, check that the “Source Path” is correct. Set the “Desnaon” eld to the Oracle 9.2.0.1 home
directory.
7. In the “Installaon Types” screen, choose “Minimum Installaon (2.2.0.18 OUI)”. Click “Next”.
8. In the “Summary” screen, make sure all cluster nodes are listed. Click “Next”.
9. When the progress screen shows compleon, click “Exit”.
10. If installing on individual nodes, repeat these steps for each node.
Install 9.2.0.5 OCFS Binaries into the Oracle Home
Perform the following steps to install the 9.2.0.5 OCFS binary les into the Oracle Home directory:
1. Start the newly installed version of OUI by choosing Start -> Programs -> Oracle Installaon Products -> Universal Installer
2. In the “Welcome” page, click “Next”.
3. In the “Node Selecon” screen, highlight all nodes {if installing on individual nodes, only select the current node).
4. In the next screen, change the Source Path so that it is poinng to E:\oracle_stage\ocfs9205\3575688\Disk1\stage\products.jar.
5. In the “File Locaons” page, enter the Oracle Home name where the OUI was installed and click “Next”.
6. In the “Summary” page, click “Next”.
7. View the installaon progress in the next screen. When the install is complete, the OCFS support les are installed in the
ORA_HOME\cfspatch directory. The les are only installed on Node 1, not on any other nodes. Click “Exit”.
8. To install on individual nodes, repeat the previous steps for all other nodes in the cluster (not necessary for a shared
Oracle Home).