Hardware manual

Group Administration Group configuration
5–3
Group configuration tabs
Each of the Group Configuration tabs provides additional information and configuration options as shown in Table
5-2:
Table 5-2: Group Configuration Tabs
Tab Name Description User Actions
General General group settings, date and time. Modifying the group IP address or group name on page 5-5
Modifying the time zone and clock time on page 5-3
Administration Administration acce
ss, RADIUS
settings, and adm
inistrative accounts.
Administration access options on page 4-2
Displaying RADIUS authentication and accounting servers on page
4-
9
Displaying local administration accounts on page 4-5
Notifications E-mail event notifications and the
event logs.
Confi
guring E-Mail notification on page 14-3
Configuring syslog notification on page 14-5
iSCSI Authentication, discovery and local
CHAP accounts.
Using CHAP accounts on a RADIUS authentication server on page
8-3
Configuring target authentication on pa
ge 8-4
Configuring the group to use an iSNS server on page
8-5
See Displaying local CHAP accounts on page 8-2
SNMP Access and traps. D
isplaying and configuring SNMP access to a Group on page 4-1
1
Configuring SNMP trap destinations on page 14-7
VD
S/VSS Access control list. Displaying and configuring Windows service access to a Group on
page
4-12
Defaults Volume settings, thin provisioning,
and iS
CSI settings.
Displaying group-wide default volume settings on page 9-5
Displaying the iSCSI target name and alias on page 9-2
Ad
vanced Load balancing, member firmware
and de
dicated management network.
Enabling or disabling performance load balancing (advanced) on
page 5-6
Updating member firmware on page
6-13
Configuring a management network on page 4-14
Modifying the time zone and clock time
To display or change the current date and time values:
Click
Group Configuration, then the General tab. See the online help for information about the data fields
and options.
To modify the group time zone and time:
1. Select the time zone and city from
the Ti
me zone pull-down menu.
2. Click
Modify group time in the Date and Time panel.
3. Change the date and time. To synchronize the time w
ith the computer running the GUI, click Set to time
of system running GUI
.
4. Click
OK to save the changes. Click Cancel or Reset to current group time to cancel the changes.