Hardware manual
Group Administration Group security
4–17
Adding a member to a group with a management network
If you add a member to a group that has a management network, you must assign the highest-numbered network
interface on the new member to the management network.
After you select the pool and RAID policy
for the new member, as described in Setting the RAID policy and pool
for a new member on pa
ge 6-6, the Modify IP Settings – Management Network dialog box appears.
In the Modify IP Settings – Management Network dialog box:
1.
Enter an IP address that is on the management network.
2. Enter a subnet mask (netma
sk).
3. Select
Enable this interface.
4. Select
Restrict to management access.
5. Click
OK.
6. Verify the configuration. See Displaying management network in
formation on page 4-16.
Modifying the management network configuration
1. Click Group, then Group Configuration, and then the Advanced tab.
2. In the Dedicated Management Network panel, click Configure management network.
3. Enter the information in the Management IP address or Default gateway field.
4. In the Modify IP Settings dialog box, double-click the
items and make your changes.
Note: Make su
re all the network addresses used in the management network are on the same subnet, which is
different from the iSCSI network.
5. Click
OK to confirm that you want to perform the operation. The Group Manager GUI automatically restarts,
using the group IP address.