Hardware manual

Group Administration Group security
4–16
Figure 4-1: Configure Management Network – Configuration Complete
8. In the Warning dialog box, click Yes to restart the Group Manager GUI session using the new management IP
address.
Note: When you configure a management network correctly, the highes
t-numbered interface is on the same subnet
as the management IP address and
Mgmt appears in the Traffic column (Figure 4-1). The remaining
interfaces for iSCSI traffic are on a different network and
SAN appears in the Traffic column.
Management network post-configuration tasks
After configuring a dedicated management network, you might need to:
• Inform administrators of the new management network IP address.
• Uninstall and reinstall the Group manager
GUI application If you have a shortcut to the Group Manager on the
computer desktop, the group address in the shortcut is not updated with the new management address. See
Uninstalling the GUI application on page
3-2.
• Update the group IP address in the application to the dedicated management address if you a
re running SAN
HeadQuarters. See the SAN HeadQuarters documentation.
Displaying management network information
1. Click Group, then Group Configuration, and then the General tab.
The management network address is shown in the
Management IP address field. (If there is no
management network, this field is not shown.) The General Settings panel also shows the group IP address,
which you use for all iSCSI traffic, including traffic between replication partners.
2. Click
Configure management network to display more detail.