Hardware manual

Group Administration Group event logging
14–7
Configuring SNMP trap destinations
You can configure network addresses to receive SNMP traps from the group.
1. Click
Group, then Group Configuration.
1. Click the
SNMP tab. See the online help for information about the data fields and options.
2. In the SNMP Traps panel, click
Add.
3. Enter the IP address where SNMP traps are sent and click
OK. You can specify up to five IP addresses. All the
addresses receive traps.
4. Optionally, modify the SNMP trap comm
unity name. The default is SNMP-trap. The group uses the SNMP
trap community when it sends SNMP traps. SNMP trap community names must be unique and can contain up
to 63 alphanumeric characters, but no commas.
5. Click
Save all changes (Control+S).
Changing the SNMP trap configuration
1. Click Group, then Group Configuration, and then the SNMP tab.
2. In the SNMP Traps panel:
• To modify an SNMP trap destination, select
the IP address, click Modify, change the IP address, and click
OK.
• To delete an SNMP trap destination, sele
ct the IP address, and click Delete.
• To modify the SNMP trap community name, cha
nge the name in the SNMP trap community name field.
3. Click
Save all changes (Control+S).to apply the modification.
Accessing PS Series array MIBs
PS Series array MIBs (Management Information Bases) contain information about SNMP traps and trap
thresholds. The group collects MIBs in an archive. You can open this archive and examine the individual MIBs, or
you can download the archive and store it on your computer.
Requirement: To
use MIBs, you must install them on a management station. Not all traps apply to all array
models.
If you have a support account, you can access the PS Series
array MIBs from the customer support website.
1. Log in to a support account and access the
Downloads web page.
2. Click the link for your PS Series Fi
rmware version.
3. Click
MIBS.