Service manual

Adjustment and Troubleshooting
4-13
Service Manual
Display Meaning Suggested solutions
Paper Jam 2... Paper has jammed in the paper exit
area.
Remove the jammed paper.
Duplex jam 0... Paper has jammed during duplex
printing.
Remove the jammed paper.
Duplex jam 1... Paper has jammed during duplex
printing.
Remove the jammed paper.
Standard Bin Full/
Standard Bin is 90%
Full
The output tray is full. The output tray can hold up to 250 sheets of plain
paper. Once the paper is removed from the output
tray, the printer resumes printing.
Optional Bin1 Full The output tray of output expander
is full.
The output expander can hold up to 650 sheets of
plain paper. Once the paper is removed from the
output expander, the printer resumes printing.
Open Heat
Open Heat Error
Power Cycle
There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the
problem persists, see the fuser error flow chart.
Low Heat/
Low heat Error
Power Cycle
There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the
problem persists, see the fuser error flow chart.
Over Heat
Overheat Error
Power Cycle
There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the
problem persists, see the fuser error flow chart.
LSU Motor Error/
LSU Motor Error/
Power Cycle
A problem has occurred in the
LSU(Laser Scanning Unit).
Unplug the power cord and plug it back in. If the
problem persists, see the LSU unit error flow chart.
Hsync Error/
LSU Hsync Error
Power Cycle
A problem has occurred in the
LSU(Laser Scanning Unit).
Unplug the power cord and plug it back in. If the
problem persists, see the LSU unit error flow chart.
Fuser Error
Fuser Fan Locked
Power Cycle
There is a problem in the cooling
fan of the printer.
Open and then close the rear door.
SMPS Error
SMPS Fan Locked
Power Cycle
There is a problem in the SMPS fan
of the printer.
Unplug the power cord and plug it back in.
Fuser Error/
Fuser Not Installed
Check Rear Door
The fuser unit is not installed or not
detected.
Install the fuser unit or open and then close the rear
door.
Inner Temp. Error/
Inner Temp. Error
Power Cycle
There is a problem in your printer
system.
Unplug the power cord and plug it back in.
Deve Motor Error/
Deve Motor Locked
Power Cycle
There is a problem in the
development motor of the printer.
Unplug the power cord and plug it back in.