Service manual

Product spec and feature
2-18
Service Manual
2.2.1.3.4 Power Save Mode
The Power Save mode allows your printer to reduce power consumption when it is not in actual use. You
can turn this mode on by selecting the length of time for which the printer waits after a job is printed before it
switches to a reduced power state.
1. Press Menu (
).
2. Press Scroll (
to ) to highlight Settings and press Select ( ).
3. Press Scroll (
to ) to highlight Setup and press Select ( ).
4. Press Scroll (
to ) to highlight Power Save and press Select ( ).
5. Press Scroll(
to ) to display the time settings you want.
The available options are 5, 10, 15, 30, 60 and 120(minutes).
6. Press Select (
) to save the selection.
7. Press Cancel (
) to return to Standby mode.
2.2.1.3.5 Changing the font setting
Your machine has preset the font for your region or country. If you want to change the font which you prefer
or set the font under special condition such as the DOS environment, you can change the font setting as
follows:
1. Press Menu (
).
2. Press Scroll (
to ) to highlight Emulation and press Select ( ).
3. Press Scroll (
to ) to highlight Setup and press Select ( ).
4. Press Scroll (
to ) to highlight PCL and press Select ( ).
5. Press Scroll (
to ) to access the required value.
6. Press Select (
) to save the selection.
7. Press Cancel (
) to return to Standby mode.
NOTE: Following information shows the proper font list for corresponding languages.
Russian: CP868, Cyrillic
Hebrew: 15Q, 8H, 0H (Israel only)
Greek: GREEK, PC737
Arabic & Farsi: ARABIC8, WINARABIC, PC864, FARSI, ISOARABIC.