User Manual
Table Of Contents
- Dell EMC PowerEdge R750 Installation and Service Manual
- Contents
- About this document
- System overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Cable routing
- M.2 SSD module
- Optional front bezel
- System cover
- Drive backplane cover
- Air shroud
- Removing the air shroud
- Installing the air shroud
- Removing the GPU air shroud
- Installing the GPU air shroud
- Removing the GPU air shroud top cover
- Installing the GPU air shroud top cover
- Removing the GPU air shroud filler
- Installing the GPU air shroud filler
- Removing the rear drive module air shroud
- Installing the rear drive module air shroud
- Cooling fans
- Side wall brackets
- Drives
- Rear drive module
- Drive backplane
- PERC module
- System memory
- Processor and heat sink module
- Expansion cards and expansion card risers
- Expansion card installation guidelines
- Removing the expansion card risers
- Installing the expansion card risers
- Removing expansion card from the expansion card riser
- Installing an expansion card into the expansion card riser
- Removing the full length expansion card risers
- Installing the full length expansion card risers
- Removing a GPU
- Installing a GPU
- Removing R1 and R3 paddle cards
- Installing R1 and R3 paddle cards
- Optional serial COM port
- Optional VGA port for liquid cooling module
- Optional IDSDM module
- MicroSD card
- Optional BOSS S2 module
- System battery
- Optional internal USB card
- Intrusion switch module
- Optional OCP card
- Power supply unit
- Trusted Platform Module
- System board
- LOM card and rear I/O board
- Control panel
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Removing the processor and heat sink module..................................................................................................108
Removing the processor........................................................................................................................................... 110
Installing the processor............................................................................................................................................. 112
Installing the processor and heat sink module.....................................................................................................115
Removing the liquid cooling module....................................................................................................................... 117
Installing the liquid cooling module......................................................................................................................... 118
Expansion cards and expansion card risers...............................................................................................................120
Expansion card installation guidelines...................................................................................................................120
Removing the expansion card risers..................................................................................................................... 152
Installing the expansion card risers........................................................................................................................157
Removing expansion card from the expansion card riser................................................................................ 162
Installing an expansion card into the expansion card riser...............................................................................163
Removing the full length expansion card risers..................................................................................................165
Installing the full length expansion card risers.................................................................................................... 167
Removing a GPU........................................................................................................................................................ 170
Installing a GPU.......................................................................................................................................................... 172
Removing R1 and R3 paddle cards.........................................................................................................................175
Installing R1 and R3 paddle cards...........................................................................................................................176
Optional serial COM port............................................................................................................................................... 178
Removing the serial COM port............................................................................................................................... 178
Installing the serial COM port................................................................................................................................. 179
Optional VGA port for liquid cooling module..............................................................................................................181
Removing the VGA port............................................................................................................................................ 181
Installing the VGA port............................................................................................................................................. 182
Optional IDSDM module................................................................................................................................................. 184
Removing the IDSDM module................................................................................................................................. 184
Installing the IDSDM module................................................................................................................................... 184
MicroSD card....................................................................................................................................................................185
Removing the MicroSD card................................................................................................................................... 185
Installing the MicroSD card..................................................................................................................................... 186
Optional BOSS S2 module............................................................................................................................................. 187
Removing the BOSS S2 module blank.................................................................................................................. 187
Installing the BOSS S2 module blank.................................................................................................................... 188
Removing the BOSS S2 card carrier blank..........................................................................................................189
Installing the BOSS S2 card carrier blank............................................................................................................190
Removing the BOSS S2 module.............................................................................................................................190
Installing the BOSS S2 module............................................................................................................................... 193
System battery ............................................................................................................................................................... 195
Replacing the system battery................................................................................................................................. 195
Optional internal USB card............................................................................................................................................ 197
Removing the internal USB card............................................................................................................................ 197
Installing the internal USB card.............................................................................................................................. 197
Intrusion switch module................................................................................................................................................. 198
Removing the intrusion switch module................................................................................................................ 198
Installing the intrusion switch module...................................................................................................................199
Optional OCP card..........................................................................................................................................................200
Removing the OCP card......................................................................................................................................... 200
Installing the OCP card.............................................................................................................................................201
Power supply unit........................................................................................................................................................... 203
Hot spare feature......................................................................................................................................................203
Contents
5