User Manual

Next steps
1. If applicable, connect the cables to the expansion card or system board.
2. If required, install the GPU air shroud filler.
3. Install the GPU air shroud top cover.
4. Follow the procedure listed in After working inside your system.
5. Install any device drivers required for the card as described in the documentation for the card.
Removing a GPU
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If applicable, disconnect the cables from the expansion card.
4. Remove the GPU air shroud top cover.
5. Remove the GPU air shroud filler.
6. Remove the full length expansion card riser.
Steps
1. To remove the GPU from Riser 1:
a. Disconnect the GPU power cable from the GPU card.
b. Open the expansion card holder latch on the riser.
c. Press the tab, and pull the card holder from the riser.
d. Hold the GPU card by the edges and pull the card from the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 161. Removing GPU from Riser 1
2. To remove the GPU from Riser 4:
a. Slide the expansion card latch on the riser.
170
Installing and removing system components