User Manual

NOTE: Ensure the anti-tilt wires on the liquid cooling module are in locked position when loosening the captive screws.
7. Set the anti-tilt wires on the liquid cooling module to the unlock position and lift the liquid module from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 117. Removing the liquid cooling module
Next steps
1. If you are removing a faulty liquid cooling module, replace the liquid cooling modules, else remove the processor.
Installing the liquid cooling module
Prerequisites
Never uninstall the heat sink from a processor unless you intend to replace the processor or system board. The heat sink is
necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud or remove the GPU air shroud.
4. Remove the expansion card riser.
5. If installed, remove the processor dust cover.
NOTE:
The procedure to install the processor onto the liquid cooling module is same as installing the processor onto the
PHM.
NOTE: Ensure anti-tilt wires on the liquid cooling module are in the unlocked position.
118 Installing and removing system components