Users Guide
Table Of Contents
- Dell™ 4610X WIRELESS PLUS Projector
- Contents
- Your Dell Projector
- Connecting Your Projector
- Using Your Projector
- Turning Your Projector On
- Turning Your Projector Off
- Adjusting the Projected Image
- Adjusting the Projector Zoom and Focus
- Adjusting Projection Image Size
- Using the Control Panel
- Using the Remote Control
- Installing the Remote Control Batteries
- Operating Range With Remote Control
- Using the On-Screen Display
- Wireless Networking Installation
- Managing the Projector From Web Management
- Make Application Token
- Troubleshooting Your Projector
- Specifications
- Contacting Dell
- Appendix: Glossary
- Index
84 Troubleshooting Your Projector
Lamp failure Lamp is defective. Replace the lamp. OFF OFF OFF OFF AMBER
Fault - DC
supply (+12V)
Power supply has been interrupted. The
projector automatically shuts down.
Unplug the power cord after three
minutes and then turn on the projector. If
this problem persists, contact Dell.
AMBER
Flashing
OFF OFF AMBER AMBER
Fault - DC
supplies
(secondary)
Power supply has been interrupted. The
projector automatically shuts down.
Unplug the power cord after three
minutes and then turn on the projector. If
this problem persists, contact Dell.
AMBER
Flashing
OFF OFF AMBER OFF
Lamp module
connection
failed
Lamp module connection may be
disrupted. Check the lamp module and
ensure that it is properly installed. If the
problem persists, contact Dell.
OFF OFF OFF OFF
AMBER
Flashing