Personal Computer User Manual
Table Of Contents
- Safety Instructions
- Preface
- Getting Started
- PowerEdge Cluster Components
- Minimum System Requirements
- Basic Installation Procedure
- Adding Peripherals Required for Clustering
- Setting Up the Cluster Hardware
- Cabling the Cluster Hardware
- Updating System BIOS/Firmware for Clustering
- Setting Up the Shared Storage Subsystem Hard-Disk...
- Setting Up the Internal SCSI Hard-Disk Drives
- Installing and Configuring Windows NT Server Enter...
- Installing and Configuring the Microsoft Cluster S...
- Installing PowerEdge Cluster Applications
- Checking the System
- Cabling the Cluster Hardware
- Configuring the Cluster Software
- Low-Level Software Configuration
- High-Level Software Configuration
- Installing Intel LANDesk® Server Manager
- Choosing a Domain Model
- Static IP Addresses
- IPs and Subnet Masks
- Configuring Separate Networks on a Cluster
- Changing the IP Address of a Cluster Node
- Naming and Formatting Shared Drives
- Driver for the RAID Controller
- Updating the NIC Driver
- Adjusting the Paging File Size and Registry Sizes...
- Verifying the Cluster Functionality
- Uninstalling Microsoft Cluster Server
- Removing a Node From a Cluster
- Setting Up the Quorum Resource
- Using the ftdisk Driver
- Cluster RAID Controller Functionality
- Running Applications on a Cluster
- Troubleshooting
- Upgrading to a Cluster Configuration
- Stand-Alone and Rack Configurations
- Cluster Data Sheet
- PowerEdge Cluster Configuration Matrix
- Regulatory Compliance
- Safety Information for Technicians
- Warranties and Return Policy
- Index

vii
W
hen Using the Computer
System
As you use the computer system, observe the following
safety guidelines:
•
If your computer has a voltage selection switch on
the power supply, be sure the switch is set to match
the alternating current (AC) power available at your
location:
— 115 volts (V)/60 hertz (Hz) in most of North and
South America and some Far Eastern countries
such as Japan, South Korea, and Taiwan
— 230 V/50 Hz in most of Europe, the Middle
East, and the Far East
•
Be sure the monitor and attached peripherals are
electrically rated to operate with the AC power avail-
able in your location.
•
To help prevent electric shock, plug the computer
and peripheral power cables into properly grounded
power sources. These cables are equipped with
three-prong plugs to ensure proper grounding. Do
not use adapter plugs or remove the grounding prong
from a cable. If you must use an extension cable, use
a three-wire cable with properly grounded plugs.
•
To help protect the computer system from sudden,
transient increases and decreases in electrical power,
use a surge suppressor, line conditioner, or un-
interruptible power supply (UPS).
•
Be sure nothing rests on the computer system’s
cables and that the cables are not located where they
can be stepped on or tripped over.
•
Do not push any objects into the openings of the
computer. Doing so can cause fire or electric shock
by shorting out interior components.
•
Keep the computer away from radiators and heat
sources. Also, do not block cooling vents. Avoid
placing loose papers underneath the computer, and
do not place the computer in a closed-in wall unit or
on a rug.










