Personal Computer User Manual
Table Of Contents
- Safety Instructions
- Preface
- Getting Started
- PowerEdge Cluster Components
- Minimum System Requirements
- Basic Installation Procedure
- Adding Peripherals Required for Clustering
- Setting Up the Cluster Hardware
- Cabling the Cluster Hardware
- Updating System BIOS/Firmware for Clustering
- Setting Up the Shared Storage Subsystem Hard-Disk...
- Setting Up the Internal SCSI Hard-Disk Drives
- Installing and Configuring Windows NT Server Enter...
- Installing and Configuring the Microsoft Cluster S...
- Installing PowerEdge Cluster Applications
- Checking the System
- Cabling the Cluster Hardware
- Configuring the Cluster Software
- Low-Level Software Configuration
- High-Level Software Configuration
- Installing Intel LANDesk® Server Manager
- Choosing a Domain Model
- Static IP Addresses
- IPs and Subnet Masks
- Configuring Separate Networks on a Cluster
- Changing the IP Address of a Cluster Node
- Naming and Formatting Shared Drives
- Driver for the RAID Controller
- Updating the NIC Driver
- Adjusting the Paging File Size and Registry Sizes...
- Verifying the Cluster Functionality
- Uninstalling Microsoft Cluster Server
- Removing a Node From a Cluster
- Setting Up the Quorum Resource
- Using the ftdisk Driver
- Cluster RAID Controller Functionality
- Running Applications on a Cluster
- Troubleshooting
- Upgrading to a Cluster Configuration
- Stand-Alone and Rack Configurations
- Cluster Data Sheet
- PowerEdge Cluster Configuration Matrix
- Regulatory Compliance
- Safety Information for Technicians
- Warranties and Return Policy
- Index

v
Safety Instructions
U
se the following safety guidelines to help protect
your computer system from potential damage and to
ensure your own personal safety. See the Preface in this
guide for information about the notational conventions
used in this manual, including the distinction between
warnings, cautions, and notes.
B
efore You Begin
Observe the following warnings while servicing this
system:
WARNING: The power supplies in this computer
system produce high voltages and energy hazards,
which can cause bodily harm. Only trained service
technicians are authorized to remove the computer
covers and access any of the components inside the
computer.
WARNING: This system may have more than one
power supply cable. To reduce the risk of electrical
shock, a trained service technician must disconnect
all power supply cables before servicing the system.
ADVARSEL: Dette system kan have mere end et
strømforsyningskabel. For at reducere risikoen for
elektrisk stød, bør en professionel servicetekniker
frakoble alle strømforsyningskabler, før systemet
serviceres.
VAROITUS: Tässä järjestelmässä voi olla useampi
kuin yksi virtajohto. Sähköiskuvaaran pie-
nentämiseksi ammattitaitoisen huoltohenkilön on
irrotettava kaikki virtajohdot ennen järjestelmän
huoltamista.
ADVARSEL! Det er mulig at dette systemet har
mer enn én strømledning. Unngå fare for støt: En
erfaren servicetekniker må koble fra alle strømled-
ninger før det utføres service på systemet.
VARNING: Detta system kan ha flera nätkablar.
En behörig servicetekniker måste koppla loss alla
nätkablar innan service utförs för att minska
risken för elektriska stötar.










