System information

12 System Information Guide
www.dell.com | support.dell.com
To install the switch in a rack:
1 Use the supplied screws to attach a mounting bracket to each side of the switch.
2 Position the switch in the rack and align the holes in the mounting bracket with the
holes in the rack.
3 Insert and tighten two screws appropriate for your rack through each of the mounting
brackets.
Stacking 3324 and 3348 Switches
PowerConnect 3324/3348 supports stacking up to six PowerConnect 3324/3348 devices.
Each PowerConnect
3324/3348 stack contains a single Master unit, while the remaining
units are considered stacking Members. All management is done through the Master unit.
Both 24-port and 48-port devices can be included in the stack.
To enable stacking, units must be stacked with an optional stacking module connected to
port G2, which is a small form factor pluggable (SFP) transceiver slot. The stacking module
should be inserted before any of the systems in the stack are booted.
NOTE: Insert the stacking module into the SFP transceiver slot, not the RJ-45 connector.
front