Specifications

4-46

Lift and remove the left door mount (C) away from the side frame, and un route the cable (D) with a spring

hook.

7. Reinstall the left door mount, and place the printer on its top.

Note: Be careful to not mar the finish of the printer.

8. Disconnect the cable (D) from J25 on the engine board.

Installation note:

• Install the two screws holding the new solenoid in place, and route the cable (D) behind the MPF clutch (E).

• After disconnecting the old solenoid cable, connect the new solenoid cable to J25 on the engine board.