Specifications

DELL™ OPTIPLEX™ 3010 TECHNICAL GUIDEBOOK —FINAL
21
COMMUNICATIONS - NETWORK ADAPTER (NIC) ( CONT.)
COMMUNICATIONS – NETWORK ADAPTER (NIC)
NOTE: MT supports full height (FH) cards and DT and SFF supports low prole (LP) cards.
1
This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernet server and
network infrastructure is required.
1
This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernet server and
network infrastructure is required.
INTEGRATED REALTEK® RTL8111E-VL
ETHERNET LAN 10/100/1000
MT DT SFF
Environmental
Operating temperature 0° C to 70° C (32° F to 158° F)
Operating humidity 20% to 80% (non-condensing)
Operating System Driver Support
Windows 7 32/64, Windows XP 32/64, Vista
32/64
Manageability (examples WOL, PXE) WOL, PXE 2.1
Broadcom NetXtreme 10/100/1000 PCIe Gigabit
1
Networking Card
MT DT SFF
Connector Type RJ45
Data Rates supported 10/100/1000 Mbps Half/Full duplex
Controller Details
Controller bus architecture (example PCIe 1.0a x1) PCIe c1.0a x1
Integrated memory 64KBytes RX, 8KBytes TX
Data transfer mode (example Bus-Master DMA) Bus-Master DMA
Power consumption (full operation per data rate connection speed) 2.84W (860mA @ +3.3V)
Power consumption (standby operation) Less than 300mW
IEEE standards compliance (example 802.1P) 802.3, 802.2, 802.3x, 802.1p
Hardware Certications (example FCC, B, GS mark…) FCC B, VCCI B, CE
Boot ROM Support No
Network Transfer Mode (example Full Duplex, Half Duplex)
Network Transfer Rate (example 10BASE-T (half-duplex) 10 Mbps
10BASE-T (full-duplex) 20 Mbps
100BASE-TX (half-duplex) 100 Mbps
100BASE-TX (full-duplex) 200 Mbps
1000BASE-T (full-duplex) 2000 Mbps
10BASE-T (full-duplex) 20 Mbps Max*
100BASE-TX (half-duplex) 100 Mbps
Max*
100BASE-TX (full-duplex) 200 MbpsMax*
1000BASE-T (full-duplex) 2000 Mbps
Max*
* Depends on the system environment.