Users Guide

135
ECO Copying
You can cut toner consumption and paper usage.
To make the
ECO copying:
1 Load the document(s) face up with top edge in first into the DADF.
OR
Place a single document face down on the document glass.
For details about loading a document, see "
Loading an Original Document".
2 Press Copy from the home screen.
3 Press the left/right arrows to select ECO Copy .
4 Press Options .
5 Press the up/down arrows to select in an environment friendly option.
6 Press the left/right arrows to select you want.
7 Press to go to the upper menu.
8 Press Start ( ) . (on the touch screen or the operator panel)
NOTE: You can cancel the copy job at any time. Press , and the copying will stop.
Book Copying
Use this feature to copy a book. If the book is too thick, lift the scanner lid until its hinges are
engaged by the stopper and then close the scanner lid. If the book or magazine is thicker than
30 mm (1.18 inches), start copying with the scanner lid open.
This special copy mode can be applied when you load a document using only the document
glass. If a document is detected in the DADF, the book copying feature does not work.
1 Place a single document face down on the document glass.
For details about loading a document, see "
Loading an Original Document".
2 Press Copy from the home screen.
3 Press Book Copy Options .
4 Press Book Copy .
5 Press the left/right arrows to select you want.
•
Both : Prints both facing pages of the book.
•
Left : Prints left page of the book.
•
Right : Prints right page of the book.