User`s guide
Table Of Contents
- Dell™ 2150cn/2150cdn Color Printer
- User's Guide
- Before Beginning
- Setting up the Printer (Printer Setup)
- Preparing Printer Hardware
- Installing Optional Accessories
- Connecting Your Printer
- Setting the IP Address
- Loading Paper
- Installing Printer Drivers on the Windows Computers
- Installing Printer Drivers on the Macintosh Computers
- Installing Printer Drivers on the Linux Computers (CUPS)
- Using Your Printer
- Dell Printer Configuration Web Tool
- Print Media Guidelines
- Loading Print Media
- Operator Panel
- Printing
- Know Your Printer
- Understanding the Tool Box Menus
- Understanding the Printer Menus
- Understanding Your Printer Software
- Understanding Fonts
- Understanding Printer Messages
- Printing With Web Services on Devices (WSD)
- Specifications
- Maintaining Your Printer
- Maintaining Your Printer
- Removing Options
- Clearing Jams
- Troubleshooting
- Troubleshooting Guide
- Basic Printer Problems
- Display Problems
- Printing Problems
- Print Quality Problems
- The output is too light
- Toner smears or print comes off
- Random spots/Blurred images
- The entire output is blank
- Streaks appear on the output
- Part or the entire output is black
- Pitched color dots
- Vertical blanks
- Ghosting
- Light-induced fatigue
- Fog
- Bead-Carry-Out (BCO)
- Jagged characters
- Banding
- Auger mark
- Wrinkled/Stained paper
- Damage on the leading edge of paper
- Jam/Alignment Problems
- The top and side margins are incorrect
- Color registration is out of alignment
- Images are skewed
- Standard 250-Sheet Tray Misfeed Jam
- SSF Misfeed Jam
- Optional 250-Sheet Feeder Misfeed Jam
- Regi Jam (Exit Sensor On JAM)
- Exit Jam (Exit Sensor Off JAM)
- Standard 250-Sheet Tray/Optional 250-Sheet Feeder Multi-feed Jam
- SSF Multi-feed Jam
- Noise
- Problems With Installed Optional Accessories
- Other Problems
- Contacting Service
- Troubleshooting Guide
- Appendix
- Index
202 Dell Printer Configuration Web Tool
NOTE: If IPsec is enabled with incorrect settings, you must disable it using the
Reset IPsec menu on the operator panel.
802.1x
Purpose:
To specify the settings for IEEE 802.1x authentication for encrypted
communication to the printer.
Values:
IPsec Settings Protocol Select the check box to enable the protocol.
IKE Sets IKE authentication. IKE is fixed to Pre-
Shared Key.
Pre-Shared Key Sets a shared key. Up to 255 alphanumeric
characters, periods, and hyphens can be used.
Re-enter Pre-
Shared Key
Enters the shared key again to confirm it.
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28,800
minutes.
IPsec SA
Lifetime
Sets the lifetime for IPsec SA from 5 to 2,880
minutes.
DH Group Sets the DH group.
PFS Select the check box to enable the PFS setting.
Remote peers
IPv4 address
Sets the IP address to connect to.
Remote peers
IPv6 address
Sets the IP address to connect to.
Non IPsec
communication
policy
Allows communication with a device which
does not support IPsec.