Personal Computer User Manual

System Setup 75
NOTE: Write down your current boot sequence in case you want to restore it.
3 Press the up- and down-arrow keys to move through the list of devices.
4 Press plus (+) or minus (–) to change the boot priority of device.
Clearing Forgotten Passwords and CMOS
Settings
1 Follow the procedures in "Before You Begin" on page 11.
NOTE: The computer must be disconnected from the electrical outlet to clear
the CMOS setting.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 15).
3 Reset the current password and CMOS settings:
a Locate the 3-pin CMOS reset jumper on the system board.
b Remove the jumper plug from the CMOS reset jumper pins 2 and 3.
c Place the jumper plug on the CMOS reset jumper pins 1 and 2 and
wait approximately five seconds.
d Remove the jumper plug and replace it on the CMOS reset jumper
pins 2 and 3.
book.book Page 75 Monday, November 19, 2012 11:42 AM