Service Manual
Table Of Contents
- Precision 3260 Compact Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tool
- Screw list
- Major components of Precision 3260 Compact
- Side cover
- 2.5-inch hard drive
- Riser card
- Wireless card
- Speaker
- Processor fan
- Memory module
- M.2 solid-state drive
- Removing the M.2 2230 PCIe solid-state drive (slot-1)
- Installing the M.2 2230 PCIe solid-state drive (slot-1)
- Removing the M.2 2280 PCIe solid-state drive (slot-1)
- Installing the M.2 2280 PCIe solid-state drive (slot-1)
- Removing the M.2 2230 PCIe solid-state drive (slot-0)
- Installing the M.2 2230 PCIe solid-state drive (slot-0)
- Removing the M.2 2280 PCIe solid-state drive (slot-0)
- Installing the M.2 2280 PCIe solid-state drive (slot-0)
- Expansion card
- Optional I/O module
- Coin-cell battery
- Heat sink
- SATA FFC module
- Processor
- System board
- Internal antenna
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
8. Route the antenna cables through the routing guides on the sides of the system board.
9. Remove the cable-protective cover from the SMA antenna.
10. Use a screwdriver remove the upper filler in the SMA antenna holes on the chassis.
11. Insert the SMA antenna module through the bottom cover inside the chassis.
12. Tighten the nut using the 8 mm wrench or with automatic screw driver.
13. Replace the cable-protective cover to the SMA antenna.
Next steps
1. Install the riser card—optional.
2. Install the hard-drive assembly—optional.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Removing and installing components 75