Service Manual
Table Of Contents
- Precision 3260 Compact Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tool
- Screw list
- Major components of Precision 3260 Compact
- Side cover
- 2.5-inch hard drive
- Riser card
- Wireless card
- Speaker
- Processor fan
- Memory module
- M.2 solid-state drive
- Removing the M.2 2230 PCIe solid-state drive (slot-1)
- Installing the M.2 2230 PCIe solid-state drive (slot-1)
- Removing the M.2 2280 PCIe solid-state drive (slot-1)
- Installing the M.2 2280 PCIe solid-state drive (slot-1)
- Removing the M.2 2230 PCIe solid-state drive (slot-0)
- Installing the M.2 2230 PCIe solid-state drive (slot-0)
- Removing the M.2 2280 PCIe solid-state drive (slot-0)
- Installing the M.2 2280 PCIe solid-state drive (slot-0)
- Expansion card
- Optional I/O module
- Coin-cell battery
- Heat sink
- SATA FFC module
- Processor
- System board
- Internal antenna
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Remove adhesive tape and place the Aux antenna stand off into the hole on the chassis.
2. Align the antenna module screw hole with the screw hole on the chassis.
3. Replace the single screw (M3x3) to secure the internal antennae to the chassis.
4. Route the antenna cable through the metallic routing guide on the computer.
Next steps
1. Install the wireless card.
2. Install the riser card—optional.
3. Install the hard-drive assembly—optional.
4. Install the side cover.
5. Follow the procedure in after working inside your computer.
Removing the SMA antenna—Location 3
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
72
Removing and installing components