Service Manual
Table Of Contents
- Precision 3260 Compact Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tool
- Screw list
- Major components of Precision 3260 Compact
- Side cover
- 2.5-inch hard drive
- Riser card
- Wireless card
- Speaker
- Processor fan
- Memory module
- M.2 solid-state drive
- Removing the M.2 2230 PCIe solid-state drive (slot-1)
- Installing the M.2 2230 PCIe solid-state drive (slot-1)
- Removing the M.2 2280 PCIe solid-state drive (slot-1)
- Installing the M.2 2280 PCIe solid-state drive (slot-1)
- Removing the M.2 2230 PCIe solid-state drive (slot-0)
- Installing the M.2 2230 PCIe solid-state drive (slot-0)
- Removing the M.2 2280 PCIe solid-state drive (slot-0)
- Installing the M.2 2280 PCIe solid-state drive (slot-0)
- Expansion card
- Optional I/O module
- Coin-cell battery
- Heat sink
- SATA FFC module
- Processor
- System board
- Internal antenna
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Pry the metallic routing guide and unroute the antenna cables from the chassis.
2. Remove the single screw (M3x3) that secures the internal antennae to the chassis.
3. Lift and remove the internal antennae away from the computer.
Installing the internal antenna—location 2
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the Internal antenna and provides a visual representation of the installation
procedure.
Removing and installing components
71