Service Manual
Table Of Contents
- Precision 3260 Compact Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tool
- Screw list
- Major components of Precision 3260 Compact
- Side cover
- 2.5-inch hard drive
- Riser card
- Wireless card
- Speaker
- Processor fan
- Memory module
- M.2 solid-state drive
- Removing the M.2 2230 PCIe solid-state drive (slot-1)
- Installing the M.2 2230 PCIe solid-state drive (slot-1)
- Removing the M.2 2280 PCIe solid-state drive (slot-1)
- Installing the M.2 2280 PCIe solid-state drive (slot-1)
- Removing the M.2 2230 PCIe solid-state drive (slot-0)
- Installing the M.2 2230 PCIe solid-state drive (slot-0)
- Removing the M.2 2280 PCIe solid-state drive (slot-0)
- Installing the M.2 2280 PCIe solid-state drive (slot-0)
- Expansion card
- Optional I/O module
- Coin-cell battery
- Heat sink
- SATA FFC module
- Processor
- System board
- Internal antenna
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
4. Replace the single (M3x3) secure to secure the internal antennae to the chassis.
5. Replace the antenna cable into securing clip on the computer.
6. Route the antenna cable through the metallic routing guides under the EMI shielding along with the chassis using a plastic
scribe.
Next steps
1. Install the wireless card.
2. Install the riser card—optional.
3. Install the hard-drive assembly—optional.
4. Install the side cover.
5. Follow the procedure in after working inside your computer.
Removing the internal antenna—location 2
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the hard-drive assembly—optional.
4. Remove the riser card—optional.
5. Remove the wireless card.
About this task
The following image(s) indicate the location of the internal antenna and provide a visual representation of the removal
procedure.
70
Removing and installing components