Service Manual
Table Of Contents
- Precision 3260 Compact Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tool
- Screw list
- Major components of Precision 3260 Compact
- Side cover
- 2.5-inch hard drive
- Riser card
- Wireless card
- Speaker
- Processor fan
- Memory module
- M.2 solid-state drive
- Removing the M.2 2230 PCIe solid-state drive (slot-1)
- Installing the M.2 2230 PCIe solid-state drive (slot-1)
- Removing the M.2 2280 PCIe solid-state drive (slot-1)
- Installing the M.2 2280 PCIe solid-state drive (slot-1)
- Removing the M.2 2230 PCIe solid-state drive (slot-0)
- Installing the M.2 2230 PCIe solid-state drive (slot-0)
- Removing the M.2 2280 PCIe solid-state drive (slot-0)
- Installing the M.2 2280 PCIe solid-state drive (slot-0)
- Expansion card
- Optional I/O module
- Coin-cell battery
- Heat sink
- SATA FFC module
- Processor
- System board
- Internal antenna
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Align the screw holes on the system board with screw holes on the chassis.
2. Replace the three screws (M2x4) to secure the system board to the chassis.
3. Replace the three screws (M3x4) to secure the system board to the chassis.
4. Align the screw hole on the speaker holder with the screw hole on the system board.
5. Replace the single screw (M3x4) to secure the speaker holder to the system board.
Next steps
1. Install the internal antenna
2. Install the interposer module.
3. Install the heat sink.
4. Install the optional I/O module.
5. Install the solid-state drive.
6. Install the riser card.
7. Install the memory modules.
8. Install the processor fan.
9. Install the processor.
10. Install the speaker.
11. Install the wireless card.
12. Install the hard-drive assembly.
13. Install the side cover.
14. Follow the procedure in after working inside your computer.
Removing and installing components
67