Service Manual
Table Of Contents
- Precision 3260 Compact Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tool
- Screw list
- Major components of Precision 3260 Compact
- Side cover
- 2.5-inch hard drive
- Riser card
- Wireless card
- Speaker
- Processor fan
- Memory module
- M.2 solid-state drive
- Removing the M.2 2230 PCIe solid-state drive (slot-1)
- Installing the M.2 2230 PCIe solid-state drive (slot-1)
- Removing the M.2 2280 PCIe solid-state drive (slot-1)
- Installing the M.2 2280 PCIe solid-state drive (slot-1)
- Removing the M.2 2230 PCIe solid-state drive (slot-0)
- Installing the M.2 2230 PCIe solid-state drive (slot-0)
- Removing the M.2 2280 PCIe solid-state drive (slot-0)
- Installing the M.2 2280 PCIe solid-state drive (slot-0)
- Expansion card
- Optional I/O module
- Coin-cell battery
- Heat sink
- SATA FFC module
- Processor
- System board
- Internal antenna
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
SATA FFC module
Removing the SATA FFC module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the processor fan.
4. Remove the hard drive.
About this task
The following image(s) indicate the location of the SATA FFC module and provide a visual representation of the removal
procedure.
Steps
1. Remove the single screw (M3x5) that secures the SATA interposer module to the system board.
2. Open the latch and disconnect the SATA FFC from the connector on the system board.
3. Lift the SATA FFC module along with the SATA FFC out of the computer.
Installing the SATA FFC module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image(s) indicate the location of the SATA FFC module and provide a visual representation of the installation
procedure.
Removing and installing components
57