Specifications

Precautions

Service Manual

5-23

5.19 Pick-Up Ass'y & Solenoid

1. Before you remove the Pick-Up Ass'y, you should

remove:

- Rear Cover (see page 5-2)

- Side Cover (LH, RH) (see page 5-3)

- Front Cover (see page 5-4)

- Scanner Ass’y (see page 5-5)

- Middle Cover (see page 5-11)

- Engine Shield Ass,y (see page 5-13)

- Drive Ass’y (see page 5-18)

- Controller Shield Ass,y (see page 5-12)

- Feed Bracket (see page 5-21)

2. Remove the Pick-Up Gear Ass,y.

3. Take out the Pick-Up Ass'y, as shown below.

4. Remove the 2 s securing the Manual Solenoid and

Pick-Up Solenoid. Then remove Manual Solenoid and

Pick-Up Solenoid.

5. To replace the pick up roller, move the stopper secur-

ing the sponge-roller to the right and then turn the

sponge-roller to remove it from the shaft.

When replacing the pick up roller only, it is possible to

remove it by turning over the set after removing the

cassette and the processor.

Pick up Gear

Ass’y

Pick Up

Solenoid

Manual

Solenoid

Shaft

Sponge Roller

Stopper

Bush