Users Guide

Using Your Projector 23
Turning Projector On
NOTE: Turn on the projector before you turn on the source
(computer, DVD player, etc.). The Power button light blinks white
until pressed.
1 Connect the power cord and appropriate signal cables to the projector.
For information about connecting the projector, see "Setting Up Your
Projector" on page 8.
2 Press the Power button (see "Using Remote Control" on page 13 to locate
the Power button).
3 Turn on your source (computer, DVD player, etc.)
4 Connect your source to the projector using the appropriate cable. See
"Setting Up Your Projector" on page 8 for instructions to connect your
source to the projector.
5 By default, the input source of the projector is set to VGA-In. Change the
input source of the projector if necessary.
6 If you have multiple sources connected to the projector, press the Source
button on the remote control to select the desired source. See "Using
Remote Control" on page 13 to locate the
Source button.
Turning Projector Off
CAUTION: Unplug the projector after properly shutting down as
explained in the following procedure.
1 Press the Power button. Follow the instruction displayed on screen to
properly turn off the projector.
NOTE: The "Press Power Button to Turn off Projector" message
will appear on the screen. The message disappears after 5 seconds
or you can press the Menu button to clear it.
2 Press the Power button again. The cooling fans continue to operate for
120 seconds.
3 To power off the projector quickly, press the Power button and hold for 1
second while the projector’s cooling fans are still running.
3
Using Your Projector