User guide
Table Of Contents
- Before Beginning
- Setting Up Printer (Printer Setup)
- Using Your Printer
- Print Media Guidelines
- Loading Print Media
- Operator Panel
- Printing
- Know Your Printer
- Maintaining Your Printer
- Troubleshooting
- Troubleshooting
- Basic Printer Problems
- Display Problems
- Printing Problems
- Print Quality Problems
- The output is too light
- Toner smears or print comes off/Stain on back side
- Random spots/Blurred images
- The entire output is blank
- Streaks appear on the output
- Pitched color dots
- Vertical blanks
- Mottle
- Ghosting
- Fog
- Bead-Carry-Out (BCO)
- Auger mark
- Wrinkled/Stained paper
- The top margins is incorrect
- Color registration is out of alignment
- Protrudent / Bumpy paper
- Noise
- Jam
- Other Problems
- Contacting Service
- Troubleshooting
- Appendix
- Index
92 Understanding the Tool Box Menus
Paper Density
Purpose:
To specify the paper density.
Val ue s:
Adjust BTR
Purpose:
To specify the optimum voltage settings for printing for the transfer roller
(BTR). To lower the voltage, set negative values. To increase, set positive
values.
The default settings may not give the best output on all paper types. If you
see mottles on the print output, try to increase the voltage. If you see white
spots on the print output, try to decrease the voltage.
NOTE: The print quality changes depending on the values you select for this item.
Val ue s:
Plain Normal* Specifies the paper density of plain paper.
Light
Label Normal* Specifies the paper density of labels.
Light
Apply New Settings After you complete the settings, press the Apply New
Settings button to apply the changes.
Restart printer to apply new
settings
Press the Restart printer to apply new settings button
to apply the changes.
Plain 0*
-3 – +3
Plain Thick 0*
-3 – +3
Recycled 0*
-3 – +3