User guide
Table Of Contents
- Before Beginning
- Setting Up Printer (Printer Setup)
- Using Your Printer
- Print Media Guidelines
- Loading Print Media
- Operator Panel
- Printing
- Know Your Printer
- Maintaining Your Printer
- Troubleshooting
- Troubleshooting
- Basic Printer Problems
- Display Problems
- Printing Problems
- Print Quality Problems
- The output is too light
- Toner smears or print comes off/Stain on back side
- Random spots/Blurred images
- The entire output is blank
- Streaks appear on the output
- Pitched color dots
- Vertical blanks
- Mottle
- Ghosting
- Fog
- Bead-Carry-Out (BCO)
- Auger mark
- Wrinkled/Stained paper
- The top margins is incorrect
- Color registration is out of alignment
- Protrudent / Bumpy paper
- Noise
- Jam
- Other Problems
- Contacting Service
- Troubleshooting
- Appendix
- Index

70 Operator Panel
6
(Cancel)
button
• Press this button to cancel a job or clear an error.
7
(Manual Duplex)
indicator
• Indicates that the printer is ready to print the second side (odd) pages
for duplex printing.
8
(Load Paper)
indicator
• Indicates that no paper is loaded or a paper jam occurred in the
multipurpose feeder.
The indicators provide information on the status of the printer and help you
locate each problem.
Indicator Status Condition
Jam Orange on A paper jam occurred.
Orange blinks The rear cover is open.
Toner Orange on The specified toner cartridge is empty or not
installed when Dell toner cartridges are used
(
Non-Dell Toner is set to Off).
Orange blinks The specified toner is low when Dell toner
cartridges are used (
Non-Dell Toner is set
to
Off).
All toner indicators blink when the printer is in
the non-Dell toner mode (
Non-Dell Toner
is set to On).
Error Orange on A fatal error occurred.
Orange blinks An error occurred.
Ready/Data Green on The printer is ready to print.
Green blinks The printer is processing or printing.
Orange on The printer is in the power saver mode.
Orange blinks The printer is canceling.
Start Green on To continue printing, press the (Start) button.
Cancel - To cancel the current job or clear the error, press
the (Cancel) button.