User guide
Table Of Contents
- Before Beginning
- Setting Up Printer (Printer Setup)
- Using Your Printer
- Print Media Guidelines
- Loading Print Media
- Operator Panel
- Printing
- Know Your Printer
- Maintaining Your Printer
- Troubleshooting
- Troubleshooting
- Basic Printer Problems
- Display Problems
- Printing Problems
- Print Quality Problems
- The output is too light
- Toner smears or print comes off/Stain on back side
- Random spots/Blurred images
- The entire output is blank
- Streaks appear on the output
- Pitched color dots
- Vertical blanks
- Mottle
- Ghosting
- Fog
- Bead-Carry-Out (BCO)
- Auger mark
- Wrinkled/Stained paper
- The top margins is incorrect
- Color registration is out of alignment
- Protrudent / Bumpy paper
- Noise
- Jam
- Other Problems
- Contacting Service
- Troubleshooting
- Appendix
- Index
Loading Paper 35
6
Loading Paper
NOTE: Use only laser print media. Do not use ink jet paper in your printer.
NOTE: For printing envelopes, see "Loading Print Media" on page 59.
1
Open the front cover by pulling out the instruction sheet.
2
Pull the paper cover out.
3
Remove the instruction sheet attached to the paper cover with adhesive
tape.