User guide
Table Of Contents
- Before Beginning
- Setting Up Printer (Printer Setup)
- Using Your Printer
- Print Media Guidelines
- Loading Print Media
- Operator Panel
- Printing
- Know Your Printer
- Maintaining Your Printer
- Troubleshooting
- Troubleshooting
- Basic Printer Problems
- Display Problems
- Printing Problems
- Print Quality Problems
- The output is too light
- Toner smears or print comes off/Stain on back side
- Random spots/Blurred images
- The entire output is blank
- Streaks appear on the output
- Pitched color dots
- Vertical blanks
- Mottle
- Ghosting
- Fog
- Bead-Carry-Out (BCO)
- Auger mark
- Wrinkled/Stained paper
- The top margins is incorrect
- Color registration is out of alignment
- Protrudent / Bumpy paper
- Noise
- Jam
- Other Problems
- Contacting Service
- Troubleshooting
- Appendix
- Index
160 Troubleshooting
Other Problems
Contacting Service
When you call for printer service, be prepared to describe the problem you are
experiencing or the error message on the display.
You need to know the model of your printer type and serial number. See the
label located inside the side door of your printer.
Problem Action
Condensation has occurred
inside the printer.
This usually occurs within several hours after you heat
the room in winter. This also occurs when the printer
is operating in a location where relative humidity
reaches 85% or more. Adjust the humidity or relocate
the printer to an appropriate environment.