User guide
Table Of Contents
- Before Beginning
- Setting Up Printer (Printer Setup)
- Using Your Printer
- Print Media Guidelines
- Loading Print Media
- Operator Panel
- Printing
- Know Your Printer
- Maintaining Your Printer
- Troubleshooting
- Troubleshooting
- Basic Printer Problems
- Display Problems
- Printing Problems
- Print Quality Problems
- The output is too light
- Toner smears or print comes off/Stain on back side
- Random spots/Blurred images
- The entire output is blank
- Streaks appear on the output
- Pitched color dots
- Vertical blanks
- Mottle
- Ghosting
- Fog
- Bead-Carry-Out (BCO)
- Auger mark
- Wrinkled/Stained paper
- The top margins is incorrect
- Color registration is out of alignment
- Protrudent / Bumpy paper
- Noise
- Jam
- Other Problems
- Contacting Service
- Troubleshooting
- Appendix
- Index
Troubleshooting 151
Auger mark
Action Yes No
1 If the printer is installed in a high altitude
location, set the altitude of the location.
1
Launch the Tool Box, and click
Adjust
Altitude
on the
Printer Maintenance
tab.
2
Select the value close to the altitude of the
location where the printer is installed.
Is them problem recovered?
The task is
complete.
Contact Dell.
Action Yes No
1 The toner cartridges may be low or need to be
replaced. Confirm the amount of toner in each
toner cartridge.
1
Check the toner level in the
Status
tab in the
Status Monitor.
2
Replace the toner cartridges as necessary.
Is the problem recovered?
The task is
complete.
Go to action 2.
2 Start Developer Stir Mode.
1
Launch the Tool Box, click
Developer Stir
Mode
on the
Diagnosis
tab.
2
Click the
Start
button.
Is the problem recovered?
The task is
complete.
Contact Dell.