User guide
Table Of Contents
- Before Beginning
- Setting Up Printer (Printer Setup)
- Using Your Printer
- Print Media Guidelines
- Loading Print Media
- Operator Panel
- Printing
- Know Your Printer
- Maintaining Your Printer
- Troubleshooting
- Troubleshooting
- Basic Printer Problems
- Display Problems
- Printing Problems
- Print Quality Problems
- The output is too light
- Toner smears or print comes off/Stain on back side
- Random spots/Blurred images
- The entire output is blank
- Streaks appear on the output
- Pitched color dots
- Vertical blanks
- Mottle
- Ghosting
- Fog
- Bead-Carry-Out (BCO)
- Auger mark
- Wrinkled/Stained paper
- The top margins is incorrect
- Color registration is out of alignment
- Protrudent / Bumpy paper
- Noise
- Jam
- Other Problems
- Contacting Service
- Troubleshooting
- Appendix
- Index
124 Maintaining Your Printer
6
Insert the cleaning rod fully into the hole beside the arrow on the printer
until its tip reaches the interior of the printer as illustrated below, and then
pull it out.
7
Repeat the same procedure for the other three holes.
8
Return the cleaning rod to its original location.
9
Replace the black cartridge by adjusting it to the associated cartridge
holder, and then insert it firmly by pressing near the center of the label
until the cartridge clicks.