Installation guide

12 Chapter 3
Step 6: Attach a Wyse Conversion Label and Microsoft License Label on Each Converted
Thin Client
The conversion kit is supplied with Wyse Conversion Labels and Microsoft License Labels
that must be attached to each thin client as shown in Figure 14. Be sure you have
purchased the amount of labels you need.
Caution
Failure to install the labels may cause delays in service and support. The
serial number must be given to a Customer Support Technician to validate
entitlement to support and service from Wyse. Failure to do so will result in
the original operating system being loaded on the device and is in breach of
your license agreement.
Figure 14 Placement of labels on the R90L
Step 7: Obtain a Firmware Update
After converting your thin clients, obtain any available firmware update at
http://www.wyse.com/serviceandsupport/support/downloads.asp
.
Warning
Use of the firmware on more than one device requires that you first purchase
from Wyse additional copies of, or licenses to, the firmware. Contact your
local Wyse distributor or Wyse Inside Sales at 1-800-800-9973 option 1 or
1-408-473-1200 option 1.