Installation guide

2 Installing Flash and RAM
This chapter contains information for Wyse C10LE, C30LE, C50LE and C90LE cloud
client users who must install new flash and RAM. If you are installing firmware only, you
can skip this chapter and proceed to "Installing WES2009 Firmware."
Caution
(C90LE Only) For C90LE users who do not have a minimum of 2 GB flash,
you must install new flash (all C90LE users have 1 GB RAM and can skip
"Step 3: Install the RAM Module"). For C90LE users who have a minimum of
2 GB flash and 1 GB RAM, skip this chapter and continue with "Installing
WES2009 Firmware."
Requirements
• Small Phillips screwdriver
• Needle-nose pliers
• (Optional) Plastic alignment tools or equivalent for prying
Warning
Flash and RAM modules may be susceptible to damage by Electro-Static
Discharge (ESD). All industry-standard cautions should be followed to avoid
ESD. Before you remove or install a module, touch any metal part of the
chassis and keep that contact with the chassis during the installation
process.