Instruction Manual

DELKRO Inc. OBLIGATIOS AD BUYERS REMEDIES HEREUDER ARE SOLEY AD
EXCLUSIVELY AS STATED HEREI.
THE LIABILITY OF DELKRO Inc., WHETHER BASED O TORT, COTRACT
WARRATY, STRICTLEY LIABILITY, OR OTHERWISE SHALL OT EXCEED THE PRICE
OF THE EW DELKRO Inc. 120cubic “Square Block” EGIE.
I O EVET SHALL DELKRO Inc. BE LIABLE FOR AY LOSS OF PROFIT, LOSS OF
USE, TOWIG EXPESES, OR OTHER ICIDETAL OR COSEQUTAL DAMAGES.
POLICY and PROCEDURES
1. DELKRO Inc. will pay a flat labor fee of $210.00 (4hrs @ $55.00ph) for the removal and
re-installation of a new DELKRO Inc. 120 cubic inch “Square Block” engine that must be
returned for warranty work.
2. DELKRO Inc. will incur the cost of shipping and handling of returned engines for warranty
to an amount not to exceed $200.00usd.
3. All warranty claims must be called into DELKRO Inc. or their designated agents prior to
the removal of any DELKRO Inc. 120 cubic inch “Square Block” engine, O FAXES
WILL BE ACCEPTED.
4. Any work of any type (other than normal maintenance) that is performed by any entity other
than DELKRO Inc. without prior written approval will OT BE REIMBURSED AD
WILL IMMEDIATELY VOID THIS WARRATY.
5. DELKRO Inc. does not assume and will not accept responsibility for cosmetic damages
incurred during the removal, installation, re-installation, shipping or handling of the new
DELKRO Inc. 120 cubic inch “Square Block” engine.
6. Labor cost for minor adjustments (Pushrod, Primary Chain, Carburetor, Etc.) during the
installation, break-in of the new DELKRO Inc. 120 cubic inch “Square Block” engine are
the sole responsibility of the installer and or dealer and will OT BE REIMBURSED by
DELKRO Inc.
7. Maintenance items, regular service items, or anything considered as a consumable item are
not covered under this warranty.
8. Due to the uniqueness of materials and interfaces of components, and our lack of control over
proper start up and warm up of the DELKRO Inc. 120 cubic inch “Square Block” engine,
we assume no responsibility for fluid weeps, seeps, or leaks at any and all gasket surfaces and
interfaces after the first sixty (60) days.
9. All warranty claims must be filed before the expiration date of the warranty.
REQUIRED EGIE BREAK-I & OPERATIO PROCEDURES
The following break-in & operation procedures must be followed for this warranty to remain in effect:
1. During the break-in and after, allow your DELKRO Inc. 120 cubic inch “Square Block” to
warm up properly before riding. Correct warm up has been achieved when the rocker covers
are warm to the touch. This is very important, during the warming process the engine
components expand and create the necessary clamp load to help the gasket / mechanical
interfaces seal.