Specifications

18
Deleld
Only for Models Ordered With Re-Hinging Option.
The re-hinging option is only available on solid door models.
1. Lift front shroud if re-hinging the control side. If re-hinging
the rear side, the shroud must be removed.
2. Open door 90˚ and lift door straight up and off hinges.
3. Remove the metal screw covers on each door-side hinge
section by sliding it down and off.
4. Remove two outer screws that mount each hinge to door,
loosen the center screw, rotate hinge 180˚, reinstall outer
screws and retighten center screw. See Photos 1 and 2.
5. Remove lock strike assembly from the face frame, remove
screws from the opposite side of the face frame and install
the lock strike. Install the screws removed to fill the original
lock strike mounting holes.
6. Pry the plugs out of the hinge mounting holes on the side
opposite the current hinge locations and set them aside.
7. Pull the wires for the hinge switch out of the large hole and
remove the plastic caps and set them aside to re-use in
step 9. See Photo 3.
8. Remove the cabinet hinge screw covers by gently prying
them out with a small screwdriver.
9. Remove all three screws from each hinge. Note that one
hinge has a hinge actuated switch to operate the lights.
Remove the wires from this switch and use the caps
removed in step 7 to cap the loose wires. See Photo 3.
Move this hinge to the opposite side of the face frame,
connect the switch wires and mount the hinge to face
frame, then mount the other hinge. Press the plugs
removed in step 6 into the screw holes from the original
hinge locations. Use a small amount of silicone sealant
under the lip of the cap if the fit of the plugs is not tight.
10. Remove the plastic cam from the hinges by pulling straight
up, then rotating the cam 180˚ and pushing back into the
hinge.
11. Remount the door and check for proper closure, gasket
seal, and light operation. Adjust hinges as needed. Once
adjustment is verified, remove the door, reinstall all hinge
screw covers and set the door back in place.
12. If additional plugs are needed due to loss or damage,
please contact Delfield Parts Department at (800) 733-
8821, extension 12801.
Door Reversal Procedures
Photo 1.
Photo 2. Rotate hinge 180º
Remove 2 outer screws
Loosen the center screw
Photo 3. Remove the caps and
reinstall them on the opposite
side switch wires