User's Manual

NAVIGATING THE SIGNAL BOOSTER MANAGEMENT TOOL
This chapter describes how to navigate the DMSB signal booster Management Tool
application and the available functions.
ACCESS LEVELS
The enabled parameters displayed by the application depend on the access mode:
User or Advanced. The default access mode is
User. While in the User level the
functions reserved for
Advanced users are disabled (fields are grayed) and are
displayed for informational purposes only.
The
User and Advanced access modes are defined as follows:
• User – Default or press CTRL + U (from Advanced mode)
• Advanced – Press CTRL + A
• Technician – Press CTRL+ T
Note: It is specified when the application requires entering the Advanced mode to define
a specific parameter.
MAIN WINDOW
The main window is used for configuring the required channels (up to 24 for both
bands). The signal booster identification information is displayed at the top part of
the window.
The main window consists of the following tabs:
• 700DL/800DL or 700/800 UL – Displays the available 700 MHz and 800
MHz band channels for the user to select from in addition to the required
filters. Also, displays center frequency (input equals output) and RSSI levels.
• Global – Displays the unit information (i.e serial number, SW version, etc.).
• Routing – Includes the FPGA Routing for transmitting CW in Test mode.
• Setup – N/A - for Dekolink Technicians only.