Installation Manual

IDEN REPEATER PRODUCT MANUAL DEKOLINK WIRELESS LTD.
1.5 SPECIFICATIONS
1.5.1 General
This paragraph provides the electrical, mechanical and environmental specifications
of the CDMA Repeater.
Note
Specifications are subject to change without notice.
1.5.2 Electrical Specifications
Parameters Downlink Uplink
Frequency Range 869 – 894 MHz 824 – 849 MHz
Pass band Gain @Min attenuation 90 dB typical 90 dB typical
Propagation Delay 5 µsec. 5 µsec.
Band Ripple ± 1.5 dB max ± 1.5 dB max
3 dB Attenuation Bandwidth 25 MHz 25 MHz
20 dB Bandwidth 29 MHz 29 MHz
40 dB Bandwidth 30 MHz 30 MHz
Noise Figure @max gain 7.0 dB 7.0 dB
IMD
In Band ≤-15 dBm/30KHz
∆f ± 750KHz≤-
45dBc/30KHz
∆f ± 900KHz≤-
42dBc/30KHz
In Band
Per Channel
∆f ± 1.98MHz≤-
65dBc/30KHz
∆f ± 1.98MHz≤-
59dBc/30KHz
In Band ≤-22dBm/30KHz
9KHz - 1GHz ≤ -36dBm/30KHz
Spurious
Emission
Out of Band
1GHz - 12.75GHz ≤ -30dBm/30KHz
Waveform Quality ρ> 0.95
Gain Control Range (by RMT
software) – User Defined
30 dB @1 dB/step 30 dB @1 dB/step
3
rd
Order Output Intercept Point
(IP3 out)
+56 dBm typical +45 dBm typical
Composite Output Power +36 dBm +1/-0 dB +24 dBm +1/-0 dB
Impedance Level 50 ohms 50 ohms
V.S.W.R In/Out 1.5: 1 max. 1.5: 1 max.
Spurious Emission -13 dBm max. -13 dBm max.
Spurious in band -45 dBc typical -45 dBc typical
Spurious out of band -13 dBm max. -13 dBm max.
Power Supply 110 to 220 VAC
Maximum Consuming Power 150 W
Page 2 Proprietary Data Pub. 311-2005 Rev. 1.0