Installation Instructions
Table Of Contents
- AND
- BOOSTER
- The switch on the RF amplifier enables the AGC function. If the AGC is disabled then the amplifier gives maximum gain.
- The AGC ON/OFF and GAIN SETTING functions for the up link path are reached by opening the small slide door located on the Booster left side, adjacent to the BASE antenna port. For the down link path the door is on the right side adjacent to the MOBILE an
- Limited Warranty
Dekolink Wireless Ltd., 16 Bazel St., Qiryat-Arieh Petah-Tikva Israel, 49510
Tel: 972-3-9180-180; Fax: 972-3- 190-9180
Email: marketing@dekolink.com
:ELECTRICAL SPECIFICATIONS
Down Link
(Base to Mobile)
Up Link
(Mobile to Base)
Frequency Range (MHz)
935-941 896-902
Passband Gain @Min attenuation 40 dB nominal
Passband Ripple +/- 1.5 dB typical
Manual Attenuation Range 0 to 30 dB in 2 dB step
Isolation between up and down link 70 dB min
Noise Figure 6.0 dB max
Amplifier Power Output
@1 dB Compression
: 10 Watts typical 1 Watts typical
3rd Order output Intercept point
+50 dBm typical +43 dBm typical
AGC Factory Power Preset +30 dBm nom. +24 dBm nom.
Impedance level 50 ohms
V.S.W.R In/Out 1.5 : 1 max
AGC Attenuation Range 25 dB typical
AGC Selection By ON/OFF Switch
AGC LED Indication LED turn ON when power reaches AGC Set
Power Level. (both at On and Off Positions).
Power Supply : 110/220V AC, 50-60 Hz
*
same specifications for both paths unless specified.
; Web site: www.dekolink.com
Rev 0 02/03 Page 6 of 9