Installation and Operating Instructions
Table Of Contents
- AND
- MW-CBDA-PCS-X-1W65-A
- CELLULAR
- BI-DIRECTIONAL AMPLIFIER
- BDA with AGC & MGC
- RF BLOCK DIAGRAM
- _
- The switch on the RF amplifier enables the AGC function. If the AGC is disabled then the amplifier gives maximum gain.
- MGC: The RF gain of the BDA can be reduced by about 15 dB using the continuos trimmer on the amplifier. The RF gain is at maximum when the trimmer is at anti-clockwise direction. To reduce the gain, turn the trimmer clockwise using a screwdriver. Turning
- The AGC and MGC functions for the uplink path are reached by opening a small cover located on the DBA side adjacent to the Mobile antenna port. For the downlink path the window is located on the side near the Base antenna port.
- Note: The BDA is shipped with the AGC switch in the OFF position and maximum RF gain.
Dekolink WIRELESS Ltd.
16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510
Tel- 972-3-9180-180 Fax-972-3- 190-9180
e-mail: marketing@decolink.com
web www.decolink.com
RF EXPOSURE WARNING
In order to satisfy the FCC RF exposure requirements, you must ensure that the
installation complies with the following:
One antenna is connected via cable that has typical 1~10 dB attenuation (depends on
the length of the cable) to the BDA BASE port. This antenna is installed outdoor and
has very sharp beam (Yagi type or similar) pointed to the donor (BTS). This type of
antenna has about 16 dBi gain. Typical specifications: gain: 8 dBd (=10.1 dBi), VSWR:
better than 1.5:1 , Impedance: 50 ohm. The outdoor antenna must be installed to
provide a minimum separation distance of 0.5 m (50 cm) from persons within the area.
The second antenna is connected via cable that has typical 1~10 dB attenuation
(depends on the length of the cable) to the CBDA MOBILE port. This type of antenna
is omnidirecttional (isotropic), or wide beam, with 0 to 2 dBi typical gain and is installed
and distributes indoor (in buildings, tunnels, basements, park lots, shopping centers
etc.). Typical specifications: gain: 2 dBi, VSWR: better than 2:1 , Impedance: 50 ohm.
The indoor antenna must be installed to provide a minimum separation distance of 0.2
m (20 cm) from persons within the area.
Page 6 of 9 CBDA PCSX 1W65 Install.doc