User Manual

Dekolink WIRELESS Ltd.
16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510
Tel- 972-3-9180-180 Fax-972-3- 190-9180
e-mail: [e-mail]
web www.dekolink.com
50W rev 1  10/03 Page 6 of 16
2.5. Repeater connection module
The connection module supplies and monitors the DC power to all the active components
of the repeater.
The repeater values are sampled here and, if needed, the relevant alarms are sent to the
remote monitoring and control. Module
2.6. Remote monitoring and control module
The remote monitoring and control module is based on a dedicated microcontroller. The
interface to this controller is via a serial RS-232C port.
There are two ways for monitoring and control of the repeater as follows:
Local Mode: Through a local serial computer connection
The host computer has dedicated software, for analysis, control and display of the status
of the repeater using a friendly Graphics User Interface (GUI).
For repeater control software installation see “Repeater Management Application
Software User Manual”.
Figure 2 - Repeater Monitoring and Control setup
PC / Laptop
BDA Repeater
Local Mode
COM1