Dekolink WIRELESS Ltd. 16 Bazel St.
Dekolink WIRELESS Ltd. 16 Bazel St.
Dekolink WIRELESS Ltd. 16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510 Tel- 972-3-9180-180 Fax-972-3-9180-190 e-mail: marketing@dekolink com web www dekolink com REPEATER OVERVIEW: The Bi-Directional Repeater assembly provides an exceptional repeater/booster performance to extend the coverage area of radio communications in buildings and RF shielded environments. Features such as high linearity power amplifiers are contributing for the overall improved system linearity performances.
Dekolink WIRELESS Ltd. 16 Bazel St.
Dekolink WIRELESS Ltd. 16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510 Tel- 972-3-9180-180 Fax-972-3-9180-190 e-mail: marketing@dekolink com web www dekolink com BDA MONITOR The BDA monitor circuit monitors the following functions: RF power transmitted by the power amplifiers. For the downlink channel a red fault LED illuminates if the power is 10 dB below the specified composite power. In normal use the downlink channel continuously transmits RF signals and this LED should be on.
Dekolink WIRELESS Ltd. 16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510 Tel- 972-3-9180-180 Fax-972-3-9180-190 e-mail: marketing@dekolink com web www dekolink com BDA MONITOR FUNCTIONS P.S. (Uplink & down link) Illuminates when the Power Supply voltage is below or above its limits. P.AMP. (Uplink) Illuminates when the uplink Power Amplifier current is above or below its specified limits P.AMP. (Downlink) Illuminates when the uplink RF Power is 10 dB below the specified composite power. L.N.A.
Dekolink WIRELESS Ltd. 16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510 Tel- 972-3-9180-180 Fax-972-3-9180-190 e-mail: marketing@dekolink com web www dekolink com ALARM TEST PUSHBUTTON DOWNLINK BDA MONITOR P.S. P.S. P.AMP. P.AMP. L.N.A. L.N.A. AGC Range AGC Range INPUT SUPPLY DOWNLINK CHANNEL BLOCK DIGRAM RF POWER DETECTION VOLTAGE SENSOR PS ALARM LNA ALARM LNA D.L/ SUPPLY CURRENT SENSOR P.AMP ALARM POWER SENSOR INPUT SUPPLY RF POWER DETECTION 50W LOW POWER ALARM (P.
Dekolink WIRELESS Ltd. 16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510 Tel- 972-3-9180-180 Fax-972-3-9180-190 e-mail: marketing@dekolink com web www dekolink com BDA INSTALLTION Install the BDA Repeater in a shielded, ventilated and easy to reach area. Use low loss cables to connect antennas to the BDA. Install the BDA close to the service area to improve output power and noise figure.
Dekolink WIRELESS Ltd. 16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510 Tel- 972-3-9180-180 Fax-972-3-9180-190 e-mail: marketing@dekolink com web www dekolink com INSTALLATION STEPS 1. Install all antennas and connect them to the BDA inputs. 2. Turn the AGC On. This AGC limits the output power of the BDA. The AGC on the Downlink path guarantees constant downlink power when and if the Donor power changes. 3. Set downlink gain to minimum; uplink gain to minimum. 4.
Dekolink WIRELESS Ltd. 16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510 Tel- 972-3-9180-180 Fax-972-3-9180-190 e-mail: marketing@dekolink com web www dekolink com RF EXPOSURE WARNING In order to satisfy the FCC RF exposure requirements, you must ensure that the installation complies with the following: One antenna is connected via cable that has typical 1~10 dB attenuation (depends on the length of the cable) to the BDA base port.
Dekolink WIRELESS Ltd. 16 Bazel St.
Dekolink WIRELESS Ltd. 16 Bazel St.
Dekolink WIRELESS Ltd. 16 Bazel St.
Dekolink WIRELESS Ltd. 16 Bazel St. Qiryat-Arieh Petah-Tikva, Israel, 49510 Tel- 972-3-9180-180 Fax-972-3-9180-190 e-mail: marketing@dekolink com web www dekolink com DEKOLINK WIRELESS LIMITED WARRANTY Dekolink Wireless [Ltd.
